Search results

Not the greatest pictures especially since I'm using a brown wire. It's tucked between the post and windshield gasket. Dave

Looks good! It's always nice to have someone play guinea pig before I commit. Dave

Yeah, I spent a little bit today trying to figure an easy way to run the wire up from the cupholders and didn't come up with a solution that isn't a little janky. The one thing I could come up with is to run the wire from the cupholder area and tuck it in under the rubber windshield gasket along...

The suspense is killing me. 😉

Looks like next to cupholders might be an easy option but need to figure out wire routing. Dave

Do you have a picture of the switch? I'm always looking for options before I commit to what I already bought. Dave

I had no clue these existed either until I Googled "dome light delay module" and this one seemed to be perfect because you can set the parameters the way you want. I was thinking about mounting the switches up near the cupholders but haven't looked to see how much space olis behind the...

It's a cute little thing, LOL. I was going to do the dome light project over the weekend but still can't decide if I want to mount the jamb switches in the same location as ZMAN put his or if I can come up with a different spot. I configured the delay for 5 seconds and a 10 minute timeout if...

I'm taking this one step further and adding a delay module so the light will stay on for a few seconds (adjustable) after shutting the door door. The module is programmable for amount of delay and also will shut light off after a few minutes if door is left open...

I was just looking on Amazon and there's a few listings for similar looking ones and they claim to be adjustable length.

More info would definitely be greatly appreciated.

I've been thinking about doing this with my new X1100.

Just got done installing mine. I removed the pot from the board and put about 8" of wire so the board wasn't hanging from it. I ended up 3D printing a knob for it.

Just sent you a private message.

I bought that manual tire changer to do the tires on my X900 that I had and it's a breeze. The hard part is trying to get the beads seated. Dave

I guess we'll see how it all unfolds when I finally get around to putting it in. I was also thinking about mounting it near the wiper switch instead of up higher where the previous pictures showed it installed by the radio, but again we will see how it all plays out. I will post an update when...

I might separate the pot from the board so there's not so much hanging on off of it and might make it easier to tuck the board in there.

Good info gents! Mine will be here tomorrow and I'll install on my 2 month old X1100. Just wanted to confirm that it's a round shaft and not D style so I can 3D print some knobs ahead of time and see what style of knob I like best on it. Dave

Looks like there's 2 different part numbers depending on serial number. Maybe the other part number is the correct one?

When I replaced the one on my X900 I took the ends off of the old cable and put them on the new one, maybe it's the same way.