Latest activity

Sorry. No ideas. Following Good luck getting to the bottom of this. Changing fluids seems like a good idea

This is embarrassing, but I'm posting it anyway. Turns out I didn't have an oil pressure problem. In fact, after adding an actual oil...

Have done everything that owner’s manual suggested including putting in a new thermostat. It runs like it should. A very low hour...

hello

Hi there, I have been looking to see if this might be too much candy for a nickel. 2008 Kubota 900 UTV, Motor in good condition...

Thanks Fedup that’s what I’m thinking too but having trouble finding a wiring diagram to find all grounds I’ll just start at one end a...

Just guessing here, but "running bad" and gauges acting up at the same time. I have no specifics for what the problem might be, but...

Having never seen (or worked on) a 2032 I have no personal experience to share. However, the symptoms you describe are indeed common to...

Hi all, I have a 2032R Series 1. I went to use it today and it cranked and ran fine. Picked up a few small limbs with the grapple and...

No bolt in the end. End is closed. Triangle end on outside of filter housing. 3 bolts hold hoising in place. There is, however, a...

Thanks Fedup that’s what I’m thinking too but having trouble finding a wiring diagram to find all grounds I’ll just start at one end a...

Just guessing here, but "running bad" and gauges acting up at the same time. I have no specifics for what the problem might be, but...

bczoom it runs good for about 10 minutes or so before it does this the first time

bczoom the tractor runs like a champ until it starts feeling like a small miss then starts the sweeping and dash lights come on like you...

If it's running bad, I could see the sweeping. Are the gauges fine when the tractor runs fine? I'd start by addressing the running bad...