I installed the little LEDs but didn't have the fight in me this afternoon to try getting one next to the shifter. I put one on each side of the vents in the middle so it lights up the floor area. And just for the record my steering wheel came off with 2 light taps on the shaft with a ball peen...
In all honesty, I think I reversed them to the way you are describing ( COM to wiper and NC to switch).
Mine is acting up so I suspect one of my solder joints failed on the potentiometer. I can't seem to find an exact replacement so I might just grab another board and use some thinner wire to...
I still find it hard to believe that they changed the wiring since there's only one part number for the wiper switch that I can find for the X1100.
Dave
I gave into peer pressure and bought 2 sets of the little lights. I'll probably do one near the shifter and was thinking about a couple mounted somewhere so they shine down on the footwell area.
I cleaned out my disaster of a garage so I can get the RTV and tractor in for the weekend so I...
On the X900 I had, I had it mounted on the A post with ty wraps and I just reached up when I had to maneuver plow. I'll probably do something similar when I finally get a plow for my X1100.
Dave
I haven't managed to buy my plow yet for my X1100 but on the X900 I had LEDs mounted high and didn't have a problem with glare. My plow was stainless so the headlights would kill me reflecting off the back of it when it was raised.
I saw that one when I was looking around for them. I decided to go with the one that I got because it was programmable to how you wanted it to operate as far as time goes.
Dave
Hopefully you don't get hung up on that since it looks like it sticks out pretty good.
As far as the delay module goes, sometimes you just have to treat yourself, LOL.
Dave
I was just thinking that maybe the windshield fits into a slot on the gasket and then the gasket gets pressed on the frame to make the deal and possibly I stuffed the wire too far and actually created a gap to the outside?
Dave
It's seam sealer on a panel seam not silicone. It's also a brand new machine. I didn't have any water leaking before running the wires up, but I'll look at it closer and when I recover from my night last night, LOL.
Just got in THE RTV and apparently the spot I ran the wires up along windshield gasket wasn't a good idea. Water leaked in so need to come up with plan B.
Dave
I decided to finish up the dome light switch and delay project today. It's setup to turn light on when door is opened and slowly dim out after 5 seconds after door is closed. It also will turn light on when you shut ignition off and shut off immediately if door closes when ignition is on. I also...
Mine is a '22, just got it in September. The orange is just a reflection and it's actually painted black. I just pulled the wire out a little so you could see where it was running, but yes it goes up and into the headliner.
Dave