Recent content by ggmanning

Just had a thought feeding cows tonight. My smallest Kubota is a B7610 tractor for the garden and tight space fence mowing. It has the same engine as the RTVx. Just for curiosity I am going to pull the max fuel adjustment screw on it and see what it measures at factory set. That engine does...

I have a Tater built Holset VVT on the bench now....... think the Bota will turn it? 😁 I do love the long bed. Just what we needed. Everything else here is orange except the Cummins trucks so it was an easy choice to replace the 10 yr old mule diesel.

I agree. Just my peddle and throttle cables were way off. Can't help myself. I know a lot about how it works now and it is a much better machine for us in spec.

I used a photo tach. Tested it out on my mill with a digital rpm readout and it was suprisingly very accurate.

It's a new x1130

I worked on the machine today. Set my max fuel limit to .540 from the initial .650. Machine ran speeds and felt like it did before losing the stock setting on this adjusment. Turned up max rpm to 3650, mine was 3120 warmed up stock. Backed the rack limit screw our 2 turns. Went back and...

After seeing he recommended just taking out the pedal stop screw I had to move on. Yeah the high idle screw will provide a stop but without the peddle stop screw engaging at the same time as the high idle stop you continually stretch the peddle throttle cable.

I agree I am just trying to get it back to the stock setting on the fuel screw.

10 4. In my case I know where the stock rack setting should be since i opened it up 2 turns initially and I was thinking put it back stock then adjust max fuel screw to the just under smoke level......then adjust the rack adjustment to the same point of just under smoke. That logic sound...

Appreciate that and was hoping you would respond. Biggest issue I have had is there is no instruction in the service manual for setting the max fuel. I am having to go on feel and speed from previous. I will play with it just a bit to try and dial it in to where it was stock because there is...

I have not touched the idle but I will be checking high idle this weekend. Is the consensus set high idle to roughly 3400 rpm?.....I have the same motor on a genset that turns 3600 continuous? I have turned out the fuel rack limit 2 turns. Definite increase in mid range umph noticeable on...

That is interesting with the cost of these machines. Probably fine though. Looks like a 7060

Whoops.....green/yellow, not blue

I had one under the hood right in the middle. A blue wire with and open bullet connector.

I have had this issue on 2 Kubotas.....tractor and mower, both diesel. Check the voltage regulator/rectifier. If you are getting charge from the generator and the battery is good it's very likely the regulator. They are cheap and easy to replace and fixed my issue both times after using a...