You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
2017 X1100C manual
- Thread starter uke
- Start date
is it the workshop manual you want? i purchased mine from a seller on ebay. my rtv is a 2014 and the manual says it is for that year so probably is important to make sure the manual you get is for your year model and serial number range. my manual is a factory workshop manual in print form.
aurthuritis Can you tell me if the repair manual for a 2014 rtv x1100c covers the removal of the rear axle coming out of the transmission. does it snap out like a car cv joint or do you have to pull the cover on the side of the trans. an take the retianing clip off that way. jonathan
Kubota RTV-X1100CR (UV CAMO W/ CAB) Parts Diagrams
Kubota Parts Catalog Lookup. Buy Kubota Parts Online & Save!
www.messicks.com
i am pretty sure it pops in and held with an internal circlip. check the messiks online parts diagram for a schematic follow the link but you will need to look in the list for rear drive shaft.
i don't think so. but i haven't looked at the wsm either. i can look but it will be a couple of days .
just give it a good hard yank.
It is a spring C clip.
Thank you! I struggled to get this stub axle out as my slide hammer crowfoot would not fit behind it as i have used on autos.
I tried a vise grip on the slide hammer, but it would pull off in 2 strokes. I thought about welding a bead for tyhe vise grip to catch on but wanted to salvage the axle if possible.
I ended up using an 1/8 steel cable and made 2-3 wraps around the back and used a cable clamp to keep it there as I saw some one doing on a car video, then added a second cable clamp on my slide and it cam out with a few pulls.
Now that the entire axle is pulled, I am going to try to salvage the axle as the only thing wrong is a torn ouuter boot.
I cleaned the joint and see no wearing or scaring and feels smooth, so i ordered a "universal" boot because Kubota does not offer an outter boot, but would be more than happy to sell you a new axle for almost $600 if you do all the work...
Thank you to everyone for this great info. The WSM service book is lacking....
I tried a vise grip on the slide hammer, but it would pull off in 2 strokes. I thought about welding a bead for tyhe vise grip to catch on but wanted to salvage the axle if possible.
I ended up using an 1/8 steel cable and made 2-3 wraps around the back and used a cable clamp to keep it there as I saw some one doing on a car video, then added a second cable clamp on my slide and it cam out with a few pulls.
Now that the entire axle is pulled, I am going to try to salvage the axle as the only thing wrong is a torn ouuter boot.
I cleaned the joint and see no wearing or scaring and feels smooth, so i ordered a "universal" boot because Kubota does not offer an outter boot, but would be more than happy to sell you a new axle for almost $600 if you do all the work...
Thank you to everyone for this great info. The WSM service book is lacking....
off brand "heavy duty" axle assemblies are moderately priced for those that need new axels.