Search results

It's in the black box that plugs into the winch. Take the 2 little screws out and the board slids right out. Dave

It's the green and brown that need to be swapped. My picture is the correct way to have buttons work as labeled. Dave

It's a quick fix if you can solder. Dave

I just bought the one from Tractor Supply last week and had to swap 2 wires in the box. https://www.tractorsupply.com/tsc/product/traveller-wireless-control-with-big-emitter-117230799--1?cm_vc=-10005 Dave

Maybe it doesn't like your choice of music:yankchain: Dave

Mike, I know the original post was about the 1100 but thought I saw the plug was for the 900 and 1100 and that's what made me chime in. Figured if the same part fit both then it was relevant. Dave

Mine is a 2014 X900 and not sure if any changes have been made since, so that's my "Disclaimer" to to the following statement. I stated in an earlier post that coast plug made the difference between launching my kids and wife into the windshield when letting off the go peddle and now they only...

It probably depends on which state and what the exceptions are. Dave

I think it could be messed with. Dave

To be honest, I don't recall if mine came with instructions. Here's a few pics of it and original. I'm sure you could rip the old one apart and adjust it to match the aftermarket one now that I'm looking at them. Dave

My hubs got done also. Dave

Interesting...mine is a 2014, maybe I need to shake the dealer down. Dave

I've been meaning to order some because mine does that also. Part# K7591-17490 Dave

My kids would hit the windshield when I would let up on the throttle before I installed it. Now they only hit it when I mash the brakes:yum: Dave

I've put about 500 or so hours on it with coast valve. Dave

It's just a plug. You take the old one out and replace it with the new one...5 minute job. Mine has been in since February or March of 2017. It's well worth it if you're tired of getting launched into the windshield. Dave

That's the one I got for my X900. So far, so good. Dave

Back in my younger years of playing with 4x4 trucks, I used to size my winch to 2x +/- my vehicle's gvw. That being said....if you had a 4000 or 5000 on your RTV and can't get it out, you have bigger problems. I would also suggest wire rope vs. synthetic if you are going to be using it in an...

Yes, UDT is the stuff to use. Dave

Just had same problem with my 2014 x900. Kubota's fix is to use a piece of hose with a plug on the end. I just used a piece of heater hose I had kicking around and put a bolt in it.