Front drive shaft u joints

P

pattyman

New member
Hey guys

I just wanted to add this, I am replacing the u joints on the front drive shaft (4x4 shaft) of my rtv 900, and I don't like paying kubota prices. I used autozone (duralast) U joints when i replaced the rear, Part # 1-1557dl

I read that a lot of guys have used percision 392 for the front, I like options so i did some cross referencing, and this is what i have come up with.

autozone part # 1-0028dl

Trw-20128

Spicer s -1500x

and of course percision 392

If u end up at an auto parts store these u joints cross reference to fit a
71-73 nissan/datsun 1200 or a 1983 toyota starlet
 
Thanks much for the information. We ALL appreciate this !!!!

We can always try to save $$$......

Kubota is just crazy with their prices on parts ....

........... two guns
 
That is good information. Like Two Guns said, those orange colored parts will about put ya in the poor house. I think there is a thread on aftermarket parts - this would be good to go there. bordercollie
 
But remember Kubota will sell you she shaft ot shall I say slip you the shaft lol.They claim its a 1 piece unit.It took me a bit to find the joint to fit the front drive sgaft.The only thing you need to do on the shaft is use a small grinder on the yoke to add a small slot on 1 side for the retainer clip to hold the cap in place properly.It dosnt fatigue it ar take any meat from it and ive had mine on for 2 years problem free and it is greaseable.
120 vs 20 yes it is a savings IMO and worth the effort.
 
You must log in or register to reply here.
Top