aurthuritis's latest activity

Rated rpm is 3400. Set it at 3600 rpm for best performance. The hst is rated for 3800 rpm.

What year? I would check the half axles ujoints if an old model or the cv joints on the newer

Just remember that the throw on a push pull cable is fixed. You adjust by loosing the u clamp on the end and then moving the whole cable...

An interesting note. The old models before the X series the hst speed lever had reverse capabilities that went unused. Some made a...

With the bell crank in its detent your push pull cable should be at it's maximum holding the pedal up. The peddle must not bind the push...

Thank you. Your info and description is excellent. Your machine is creeping because the controls are out of adjustment holding the...

It is all in the x1100c workshop manual

The method i use came right out of the rtv x1100c factory service manual. The only adjustment to the servo is to center it so that the...

John deere and caterpillar batteries are excellent long lasting batteries with great warranty. I have had similar results with napa...

The rtv 1100 doesn't have a fan mounted on the water pump pully like the x1100c. The fan on the left side behind the cab must turn on...

Sticky shifting really isn't because of pressure in the hst. It is more because of gear lash friction that can be caused by the machine...

I have had a few recall on my x1100c. There was some suspension issues at first and then the fire flap and lastly the floor mat. My...

If you only have slight problems getting out of gear try pulling out of gear with no peddle and just as the machine has that last inch...

There's two issues with the pre 2024 rtv shifting. The first is the straight cut gears in the gearbox that as the machine sets on an...

Starting the engine to raise the bed won't affect your oil level that much,just start raise shut off and check then wait a minute and...