Recent content by pepr

Intermittent flopping and squealing noise. Inspected today and both CV joints are sloppy allowing the shaft to rub the perforated shield beneath it. Sorry for the delayed response.

Thank Border Collie! Amazing that axles are readily available, but not the front drive shaft (propeller shaft).

Hello All. Tried to search this subject, but search option wouldn't allow time to enter subject. So, I'm hear a new noise while traveling. Crawled under while NOT traveling and shook the from prop. shaft near the front cv joint. Seems loose to me. Who's performed repairs to the prop...

It's been a while since I've posted on this great forum. Just wanted to share that my 2011 RTV 900 XT continues to support our farm every day. Still on the original tires and battery. Have replaced rear u-joint once and have had some issues with the water thermister. Folks for a piece of...

Hello All! It"s been a good while since I've participated in this great forum. Retirement has elevated my workload. During this past summer my RTV overheated a few times. Some of you may remember previous similar issued that occurred on my boat. This time instead of replacing the thermister...

sfvickery, I have the OEM high rise intake/air filter on my 2011 900xt and yes the filter is a high capacity filter that is different from the fro the original filter. Now I don't know if the original filter will appropriately fit the high rise. I've had mine since 2011 and have not replaced...

I purchased my 1st new diesel truck in Dec 2014. At this time I have a whopping 10,500 miles on the truck. Me, being a retired engineer leads me to a lot of research. Use to be that Rotella was the diesel engine oil. Turns our for at least some of their oils, they have reduced the additives...

BC, Kroil is some GREAT penetrant. Not cheap, but only takes a little bit!

Boxcarman, my 2011 RTV 900 XT shift easily unless it's on a hill and in gear. The 2011 also received a factory update that significantly reduced the engine/transmission braking when taking your foot off the accelerator while still rolling in gear.

Thanks Thunderdome and I echo you wish to all NTT Fathers!

His occupation affects his ability to respond. Peanut performs professional welding at ocean drilling rigs making it unlikely for him to check email, phone calls, or NetTractorTalk. He is gone sometimes for a month or longer at a time. I now recall my stickstopper issue. The curvature was...

Folks, Peanut is a great member of this forum. He has gone out his way to design and produce quality aftermarket products for us, while NOT owning a Kubota. We all make mistakes from time to time as has Peanut for which he has corrected the mistakes. Peanut has a profession that makes him...

$50k, ouch!

So I have thought, and that by itself should alarm you. It is likely that we use the bed hydraulic lift sparingly; however, the little pump that produces the hydraulic flow for the lift is running anytime the engine is running. Am I right? So yes, I have not change the hydraulic lift fluid as...

Okay, I'll ask. What in the world is a U-25 hoe??????