Recent content by ossix

Long story short. The circlip retaining the block on the center of the ram of the steering cylinder was ground up into a million pieces. I ended up buying a used cylinder on ebay (came with the controller and all the hoses too). I tried to buy a new cylinder but Kubota doesn't have any in...

Hi bczoom. Yes, it's definitely full. It was always full, and it's been re-filled after a complete drain & flush. We're going to test the cylinder itself, as we suspect the inner seal is damaged and fluid is passing unrestricted between the left and right chambers.

This forum has been a great resource so I hope someone can help me again. I installed rear tracks on my 2009 RTV900 and was zipping around the field to test out the traction in about 2" of snow. After about 10 minutes I lost all power steering. I could turn the wheels manually left to right...

Yes, I did bczoom. It looks to be a perfect fit. I have the diamond plate all ready to go - just waiting for some warmer weather to finish the sandblasting & painting. Thank you again.

bczoom - that would be a fantastic start to the project. At least a great incentive. I am happy to pay for shipping. Alaskanassasin - The rubber mats were problematic. Apparently they trapped dirt, salt, sand & mud and if not cleaned properly it would eat the floor right out. Front mud flaps...

That is absolutely what I should have done. Too late now - the original pan is gone completely at this point.

I recently bought a 2009 RTV 900. Probably paid too much for it but I've been looking at them for some time and finally pulled the trigger. Cab, heat, hydraulics - everything works - which is great. I knew it had some rust issues so before mounting the plow I stripped the front end down to...