Recent content by bczoom

OK, I'll go in a different direction. You didn't say the age of your tractor but... Battery cables can look good on the outside but are rotted out in the inside. You can see volts but they can't deliver amps. Run jumper cables in parallel to the battery cables. To ground and to starter. In...

Is that a name brand or meaning "versatile" in general? If the latter, hell yes, depending on conditions and implements,

I thought the same but I've stalled my 2004 several times going up hills (before I figured out to back off the pedal).

Are you mashing the go-pedal to the floor when trying to climb hills? When you start to bog down, let OFF the pedal to somewhere around the half-way mark. You'll hear the RPM's raise back up and you'll have more power.

How about an ABS plastic sheet, secured with the aforementioned DJ O-clamps? https://www.eplastics.com/sheets/abs/textured-general-purpose

I have the OEM plastic roof and it's worked very well. Haven't thought about the DJ O-clamps in a long time. You can make whatever you want to with those things. My windshield and other things are all done via those O-clamps.

If I'm just puttering around, I get no reading on the temp gauge. If I give it some hard work, be it climbing a steep hill or going down the road at full speed for a mile or so, my gauge climbs to 1/2 like yours does. I can't even remember the last time my fan came on.

If you don't mind saying, can you tell me what you paid for it? I have a very low hour 2004 I've been thinking of selling but not sure what market value is nowadays.

See if this helps. https://fuseboxinfo.com/index.php/machines/107-kubota/5429-kubota-utility-vehicle-rtv-x1100c-fuses

Welcome to the forum. ;) I don't recognize the tractor. Not a lot left, The VIN plate is "normally" behind the tractor seat. Best wishes. :)

Here's the rubber floor mat. Might be able to use it as a template in whole or part. https://www.messicks.com/parts/kubota/K7611-55314

I have a 2004 RTV (It's turning 20 years old in a couple months). The floor is pristine. IMHO, keeping it dry and chemical free is key. Like you, I power wash it. I then let it thoroughly dry before putting it away. I also use Fluid Film on the perimeter. I keep mine garaged which I'm sure helps.

Just found this. https://www.orangetractortalks.com/forums/threads/rtv-900-fender-and-floor-replacement-printable-pattern.67942/

I couldn't find anything online either. Can you call or visit a dealer?

Thanks for the heads-up on Talstar. I just ordered a gallon.